CHEMCO COMPLETE MAJOR REFURBISHMENT PROJECT

23/11/2016 10:00

The ballast tanks (over 35,000m²) on board a crude oil tanker were suffering from severe corrosion damage. The vessel went to dry-dock in September 2016 to undergo major refurbishment works.

   
Original Conditions

Due to other ongoing refurbishment works going on throughout the vessel, there could be no disruption to these services. Grit blasting was therefore not allowed to be utilised and a solvent-free coating solution had to be used.

The corroded and damaged areas which were to be coated were High Pressure Water Jetted (HPWJ) to prepare the surface for application. Hard to reach and inaccessible areas were mechanically prepared.

Prior to coating application, the substrate was fresh water washed to remove any surface contamination.

   
After Surface Preparation

Two spray coats of solvent-free, wet & rust tolerant epoxy Epo-chem™ RS 500P were applied. Between these coats, a stripe coat of Epo-chem™ RS 500P was applied to all bar edges, welds, scallops and inaccessible areas.

   
Completed Application

By using this unique combination of water jetting and a solvent-free coating system, substantial time and cost savings were achieved. As no other ongoing trades were affected during the ballast tank refurbishment process, further time and cost savings were also obtained by the ship's owner.

The following benefits can be achieved by utilising this revolutionary coating technology:

  • Solvent-free
  • Wet & rust tolerant
  • No grit blasting requirements
  • Quick return to service (coating systems can 'continue to cure' underwater)
  • Tanks can begin to ballast after only a few hours
  • No disruption to other ongoing maintenance work (including hot work)
  • No recoating limitations

For more information on these two unique coating systems, please click on the product name below:

 


Enquiry Form

Enter your details below and we'll get back to you as soon as possible.



Details